2013 - Most Viewed Post #4 - Replacing a Homeplate Without a Surveyor

As 2013 reaches the finish line, here is the 4th most viewed blog post of 2013:

The homeplate of a baseball/softball field is the point where all other points are based.  (foul poles, bases, pitching rubber, etc)  So, when the time comes to replace a plate, take special care to ensure that the new plate is square with the foul poles and the field alignment is not compromised. 

Let’s walk through a plate replacement.  

First, string lines are pulled from behind the old plate to the foul poles.  This is done before the old plate is removed:

Next, a laser is used to take elevations around homeplate.  I always like to have the homeplate slightly higher than the highest point in the turf.  This will ensure that water will not run back onto the plate during rain events:

A string line is also pulled from behing the apex of the plate, through the middle of the pitchers rubber and the middle of the anchor of 2nd base.  This is the third string to ensure proper alignment.  Keep in mind that when the elevation of the plate in changed, the pitching rubber elevation should be checked and adjusted if necessary:

Finally, carefully install mound clay around the plate making sure that the plate does not move:

To see how to renovate a plate on a budget, click HERE:

Go to j-dturf.com to learn more about J&D Turf.

Play on!

--Jamie

@JamieMehringer